QuickSiteCalc

Home › Mortar Mix Calculator

Mortar Mix Calculator

Site-mixed mortar from raw materials — the 94 lb cement bags and tons of sand to buy for a volume of finished mortar, at the sand : cement ratio you pick.

Type your numbers — the result updates live.

Prices are editable estimates — change them to your supplier's prices. There is no waste factor on this one: the cement is bought by the bag, so the bag count is simply rounded up, and the sand is figured to the exact fraction of a ton. Estimate only, not a quote.

Formula

Dry volume = wet (finished) volume × 1.30 — dry ingredients bulk larger loose than the mortar they make  ·  Cement = dry volume ÷ (sand parts + 1), and 1 cu ft of cement ≈ one 94 lb bag (cement weighs about 94 lb per cu ft)  ·  Sand = dry volume × sand parts ÷ (sand parts + 1)  ·  Sand tons = sand cu ft × 100 lb per cu ft (dry sand) ÷ 2,000

Solved example

10 cu ft of finished mortar at a 4 : 1 mix: dry volume = 10 × 1.30 = 13 cu ft. Cement is 1 part in 5: 13 ÷ 5 = 2.6 cu ft → 3 × 94 lb bags. Sand is 4 parts in 5: 10.4 cu ft ≈ 0.52 tons. At $12 per bag and $45 per ton: 3 × $12 + 0.52 × $45 = $59.40.

FAQs

Why is the dry volume 30% bigger than the mortar I end up with?

Loose, dry sand and cement are full of air gaps. Wetting and mixing collapses those gaps — the sand grains pack in around the cement — so a batch of finished mortar comes out smaller than the dry ingredients that went into it. Multiplying the finished volume by about 1.30 is the standard allowance for that shrinkage.

Which ratio should I mix?

The ratio is parts of sand to 1 part of cement, measured by volume. 3 : 1 is a rich, strong mix for structural work, retaining walls and below-ground masonry. 4 : 1 is the general-purpose bricklaying mix. 5 : 1 and 6 : 1 are leaner mixes for blockwork, internal walls and other low-stress work. For anything structural, your spec or local code decides the ratio, not habit.

Does this figure lime or plasticiser?

No — this is a straight sand-and-cement mix. Many bricklayers add lime or a plasticiser for workability; a common lime mix is 1 : 1 : 6 (cement : lime : sand). If your mix includes lime, it takes the place of part of the cement share, so treat this calculator's cement figure as the total binder and split it accordingly.

How is this different from the mortar calculator?

The mortar calculator counts ready-bagged 80 lb premix — about 7 bags per 1,000 bricks, or 1 bag per 9 blocks — where you just add water. This one figures the raw cement and sand for mixing mortar yourself by volume: cheaper on big jobs, but you supply the materials, the mixer, and the discipline to keep the ratio the same in every batch.