Home › Drywall Repair Cost Calculator
What a professional drywall repair should cost — a rough estimate from the damaged area at a rate per square foot, with the minimum job charge most pros apply built in.
The rate and the minimum charge are editable estimates — change them to a quote you actually get. There is no waste factor on this one: a repair is priced on the damaged area, and the minimum charge applies however small the patch. This is a rough estimate for a professional repair — actual quotes vary by damage type, texture matching and region.
Area cost = damaged area (sq ft) × repair rate per sq ft · Estimated total = whichever is GREATER — the area cost or the minimum job charge · The rate covers cutting out the damage, patching, taping, mudding and sanding back to a paint-ready surface; painting afterwards is usually quoted separately
10 sq ft of damage at $12 per sq ft = $120 of area cost — under the $150 minimum job charge, so the estimated total is $150. A larger 25 sq ft repair at the same rate comes to $300 — above the minimum, so the area cost is the total.
A repairer's real costs — travelling to you, protecting the room, mixing compound, and returning between coats as each one dries — barely change between a doorknob hole and a whole sheet of damage, so most charge a minimum, commonly around $100–$200. That is why one tiny patch costs what it does, and why it pays to have several small repairs done in a single visit.
Cutting out the damaged board, fitting a new piece, taping the joints, two or three coats of compound, and sanding back to a flat, paint-ready surface. Matching a textured finish (orange peel, knockdown, skip trowel) takes extra time and skill and is often priced on top, and painting the patch is usually a separate line on the quote.
Water damage that has spread further behind the wall than it shows, mould that needs remediation first, damage in a ceiling (working overhead is slower), and cracks that keep reopening because the cause is movement in the building. This estimate is a sanity check on quotes — if one comes in far from it either way, ask exactly what is included.
Often, yes — a hole under about 4 in across is a classic DIY patch with a self-adhesive mesh patch or a small offcut of board and a tub of filler, for a few dollars of material. The minimum charge is exactly why a pro is poor value for that one tiny job; bigger areas, ceilings and textured finishes are where the professional finish earns its money.