Home › Deck Footing Calculator
Concrete for deck footings — the footing count for a simple grid layout, and the concrete to fill them, in cubic yards and 60 lb bags.
Price is an editable estimate — change it to your supplier's price. Cost = total quantity (with waste) × your price. Estimate only, not a quote.
Footings per beam row = floor(deck length ÷ footing spacing) + 1 · Total footings = footings per row × beam rows · Concrete per footing = π × (diameter ÷ 24)² × depth in feet · Cubic yards = total cu ft ÷ 27 · Bags (60 lb) = total cu ft ÷ 0.45, rounded up · Footings are counted on a simple grid — confirm the layout, spacing and footing size with your local code before you dig
A 16 ft deck with footings every 6 ft along 2 beam rows, each footing 12 in across × 36 in deep: floor(16 ÷ 6) + 1 = 3 footings per row — 6 footings in total. Each footing takes π × 0.5² × 3 ft = 2.36 cu ft, so the pour is 14.14 cu ft = 0.52 cubic yards = 32 × 60 lb bags.
Footing spacing follows the joist span, the beam span and the load the deck carries — it is set by the span tables and footing table in your local building code, not by a rule of thumb. Enter the spacing from your deck plan or permit drawings; this calculator counts the footings and the concrete for the spacing you give it, on a simple grid.
The bottom of the footing must sit below your local frost line so frost heave cannot lift the deck — frost depth is published by your local building department and runs from a few inches in warm states to 4 ft or more in the far north. The fence post depth calculator works through the same frost-line rule.
Either works. A cardboard tube form (figured by the sonotube calculator) gives a clean, round footing and uses the volume in this calculator almost exactly; a plain dug hole with a flared bottom uses a little more concrete, which is what the waste factor covers.
No — footings and their concrete only. The deck calculator figures the decking boards and joists on top.