QuickSiteCalc

Home › Ramp Slope Calculator

Ramp Slope Calculator

Ramp slope from a rise and a run — the ratio, the grade percent and the angle, and whether the slope stays within the 1:12 maximum for an accessible ramp.

Type your numbers — the result updates live.

No cost line here — this one is geometry / sizing, not a material quantity. Cost depends on the material and installer you choose.

Formula

Slope ratio = 1 : (run ÷ rise, both in the same units)  ·  Grade % = rise ÷ run × 100  ·  Angle = arctan(rise ÷ run)  ·  Run needed for a 1:12 slope = rise × 12

Solved example

A 24 in rise with a 24 ft run (288 in): 288 ÷ 24 = a slope of 1 : 12.0 — a grade of 8.33% at an angle of 4.76°. A 1:12 slope for this rise needs exactly 24.0 ft of run, so this ramp meets it. Shorten the run to 20 ft and the slope becomes 1 : 10.0 (10.0%, 5.71°) — too steep for an accessible ramp.

FAQs

What is the maximum slope for a wheelchair ramp?

1:12 — one inch of rise for every twelve inches of run — is the maximum running slope for an accessible ramp under the ADA standards. Anything steeper is not classed as an accessible ramp, though the standards allow limited steeper exceptions for very small rises in existing buildings.

Is the slope ratio the same as the grade percent?

They describe the same steepness two ways. A 1:12 slope climbs 1 unit over 12 units of run; as a percent that is 1 ÷ 12 × 100 = 8.33%. Road and drainage work is usually quoted in percent, accessibility in ratios, and this calculator shows both, plus the angle in degrees.

What else does an accessible ramp need besides the right slope?

Level landings at the top, bottom and every change of direction, handrails on both sides when the rise is over 6 in, edge protection so a wheel cannot slip off, and a cross slope no steeper than 1:48. This calculator figures the running slope only — check the ADA standards and your local code before building.